Awlgrip High Build Epoxy Primer D8002 QT

High Build Epoxy Primer is an epoxy surfacer used where high build and filling is required. For above waterline use only.
Product Components, Reducers, Additives, and Auxiliary Components
Yellow Base................................................D9002
Off White Base ..........................................D8002
Converter ..................................................D3002
Standard Reducer for Epoxy Primers .............T0006
Medium Evaporating VOC Exempt Reducer (NA only) ........T0176
Equipment Cleaning: Acetone, T0006, T0176, T0002 Reducers or M.E.K.

Surface Preparation
Best when used as a surfacer over other Awlgrip Primers and fairing compounds. May be applied directly to properly prepared wood or fiberglass; however, the best results are obtained when these surfaces are first sealed with 545 Primer. Gelcoat/Fiberglass: Sand with 100-150 grit paper. Wood: Smooth sand with 80-100 grit paper.

Mixing and Reduction
Mix by volume one part Base with one part Converter to a smooth, homogenous mixture.
Induction Time after Mixing: 15 Minutes
Reduce 10-20% with appropriate reducer. Example: 8 oz. Base: 8 oz. D3002: 3.2 oz. T0176
Anticipated Pot Life at 77F(25C)/50% R.H: 8 Hours. Higher temperatures may shorten pot life.

Application Instructions
Spray: Apply High Build Epoxy Primer in even coats of 8 - 10 mils (200 - 250 microns) wet film thickness yielding 4 - 5 mils (100 - 125 microns) DFT. 2 - 3 coats may be required.
Do not apply paint materials to surfaces warmer than 105F (41C) or colder than 55F (13C). Do not attempt to cure products at temperatures below 55F (13C).
 

CLICK HERE for Additional Technical Data, MSDS, and Application Guidelines!