Awlgrip Repair E3001 for Awlcraft SE or Awlgrip HDT

TDS – AwlGrip Repair

SDS – AwlGrip Repair

Volume Solids

• Awlgrip Repair Basecoat Foundation Coat (E3001) - 10.37% (MS 13.31%)
• Awlgrip Repair Basecoat Blender (T0190) - 9.76% (MS 11.70%)
• Awlgrip Repair Topcoat Blender (T0195) - 0.025% (MS 0.03%)

Specific Gravity

• Awlgrip Repair Basecoat Foundation Coat (E3001) - 0.89
• Awlgrip Repair Basecoat Blender (T0190) - 0.93
• Awlgrip Repair Topcoat Blender (T0195) - 0.84

Available Packs All products are available in Quart size packs

Base OE3001 - Awlgrip Repair Basecoat Foundation Coat
OT0190 - Awlgrip Repair Basecoat Blender
OT0195 - Awlgrip Repair Topcoat Blender

TDS – AwlGrip Repair

Surface Preparation
The surface preparation advice provided, and equipment suggestions, can be used as a guide. Preparation techniques and results will vary according to individual conditions, equipment choice/condition and other factors. Testing on a non-critical area should be carried out prior to full-scale preparation. The surface preparation of the area to be repaired is described in the separate repair manuals for Awlcraft SE and Awlgrip HDT.

Mixing & Reduction
Mixing and reduction requirements will vary according to individual conditions, climate, equipment choice/condition and other factors. Mixing and application of a small sample before full-scale application is recommended. The mixing and reduction instructions for the repair products are described in the separate repair manuals for Awlcraft SE and Awlgrip HDT.

Application
Application equipment and parameters are given as a guide. Actual equipment choices will vary according to application conditions, equipment condition and other factors. Testing on a non-critical area should be carried out prior to full-scale application. Contact your local technical service representative for further advice if necessary.
For use and application of the Awlgrip Repair Products please refer to the separate repair manuals for Awlcraft SE and Awlgrip HDT.

Recoatability & Drying Times
The data given for recoatability is not exhaustive. Actual recoatability can vary according to individual conditions, climate and surroundings. If unsure, consult your local technical service representative before proceeding. The recoatability information and recommended drying times for the repair products are described in the separate repair manuals for Awlcraft SE and Awlgrip HDT.

Warning Notes
Do not use unless mixed thoroughly with the curing agent at specified ratio.
Do not use below 13°C/55°F or warmer than 40°C/104°F. Proper application and/or cure results may be more difficult to achieve when conditions are outside this range.
Avoid conditions of low temperature with high humidity as this can result in the formation of a surface by-product that must be removed by either detergent wash followed by fresh water wash, or by sanding.
Check with local authorities to determine VOC restrictions in your area.
Please ensure a risk assessment is carried out to assess the level of PPE required for the particular task undertaken when using this product.