Blue Water Marine Mega Gloss Primer

Limitations: Do not apply if material, substrate or ambient temperature is
below 50°F or above 95°F.
Finish: Gloss
Vehicle Type: Polyurethane Alkyd Resin
Solvent Type: High Flash Naphtha
VOC: 3.76 lbs. / gal (450 grams / liter)
Solids By Weight: 50%
Weight Per Gallon: 10 lbs. per gallon (varies by color)
Recommended Dry Film: 4.0 mils
Coverage: Theoretical coverage at two mils dry is 400 square feet per gallon,
and recommended thickness of 4 mils dry would require 2 full coats. Material
losses during mixing and application will vary and must be taken into consideration. Expect 50% less coverage on bare, rough or sandblasted surfaces.
Viscosity At 75°F (24°C): 70-80 KU
Average Dry Time 75°F: Dries to touch in 4 hours. Lower temperatures & higher humidity will slow down dry times.
Recommended Reducer: Xylene for spray application, Hi Flash Naphtha for brushing or rolling
Resistance To: Chemical Resistance, Abrasion, Oils, Grease, Rust, Corrosion,
Mildew, Chipping and Fading
Pot Life: Not Applicable
Shelf Life: Maximum 12 months
Mixing: Mechanically mix for 10 minutes, making sure that all solid material is mixed thoroughly.
Cleanup: Xylene for Equipment.

Suggested Uses: Topside, Decks, Cabin, Masts, Bilge, Waterline, Boot top Striping

​Application: Brush, Spray or Roller
Roll: 1/2” nap mohair metal, lambskin, phenolic core roller. Keep roller wet. Roll in one direction, rewet, then cross roll. The product can be reduced as needed with Hi Flash Naphtha to allow proper flow out and performance.
Spray: Conventional Air Gravity Feed 59-70 psi, Tip Size .055 -.070, Airless 2200-2500 psi, Tip Size .013-.017. The product can be reduced with Xylene as needed for proper flow out and performance. For Air Spray reduce 25% with enamel reducer (Xylene.).
Surface Preparation: Water blast surface to remove all loose paint, dirt, oils, and grease. Abrade with 240 grit dry sandpaper or equivalent. Solvent wipe down to remove all sanding residue.